Search results

Hey everyone, I'm hoping to find in the Everett WA area, someone who has a bare 29-31 frame I can take some measurements from, specifically from the cowl forward. Please do not refer to the Westcott drawing, it contains conflicting dimensions. Thank you ��

Found!! Thanks to all that responded 1928 1929 front crossmember needed. Thanks!

I'm trying to get my motor running, I'm worn out from hand cranking. Hoping someone in the area (Everett WA) has one laying around. Thank you

I recently made a purchase of parts from a popular Model A supplier so I could could perform a complete rebuild of my distributor. When I received the parts I noticed the ends of the upper and lower shafts were not machined to be centered. When I contacted the supplierand asked the question, I...

I wanted to run this by everyone. I will be attempting to to see if this motor will run. 12v neg. ground, hot wire to resistor then to (-) coil, (+) coil to ignition switch, switch to distributor. I won't be able to try it until after all the time up parts arrive, does this seem correct? This is...

So I bought this 31 rolling chassis which included motor, trans, and cowl. Having never owned anything this complete, I'm trying to see if I can get her running. One thing I didn't realize is what the threaded hole on the side of the distributor was for. So after some research I learned and...

I've recently acquired a 31 rolling chassis with motor and trans. Unknown if it's a runner or not, so I've removed the oil pan and pump to clean. When I removed the pump there was no screw in the passenger side block. Upon reinstall, I threaded a bolt lightly in the hole to hold the pump. Pan...

Found locally, please remove. Thanks all who replied. Would like an original, need to crank over my motor, starter not working.

I need to replace the upper hinges on the cowl posts, how are you supposed to get to the bolts?

28-29 Tudor body side short hinge UPDATE: I only need the short (upper/mid) body side hinge. Thank you!

FOUND-PLEASE DELETE Curved panel over door 1928-29 Ford Tudor sedan In need of this panel over the driver side door. No repops please.

15" Ford / Mopar wheels similar to the picture, 4.5 / 4-1/2 pattern with clips / tabs for hubcaps similar to the attached picture. I only need 2, would like to find locally if possible. These are for my 1948 Dodge B1B pickup. Thanks!

Both sides needed for 1926 1927 Tudor Sedan. Thanks

I recently purchased a 1927 Tudor body, without any door. The owner said he had cut the subrails (just ahead of the rear portion of the door openings) so he could transport it to the swap meet easier. I was going to tack it back together so I could begin mock-up, but realized the subs do not...

For a 1927 Tudor Sedan. Need driver, passenger, or both - tudor only. Thanks!

For a 1927 Tudor Sedan. Need driver, passenger, or both - truck only. Thanks!

Needed for 1927 Ford Tudor sedan. I'm told 28-29 truck doors will also work. Prefer local, or at least Pacific NW. Thanks...

Is there an easy way to test front shocks when buying them used? I ca not imagine there is, since they typically support a lot of weight. Any ideas? Thanks!

Okay, so now I have a 1931 Fordor body that has no sub frame. Searching high and low for a supplier that sells a sub frame for this body. I’m told [by a guy at work] that all 1928-31 Fordors has a wood sub frame, since these bodies were not made by Ford, but by Murray & Briggs. Is this true...

What have you? I need one or both