Search results

Does anyone have a picture they could share of how the wiper motor switch comes out of the headliner? Thanks!

I've been looking online and became aware of the existence of anchor brackets for mounting the seat track to the floor. Did these exist on a 1939 Coupe? Were they welded or bolted to the floor? Does anyone have a picture of them in case I have to re-create them. I don't see that they are...

I’m looking for the glass lens out of the 1939 or 1938 Deklite trunk handle base. Please message me if you have one you’d part with. Thanks!

I am looking for the center support brace that connects the package tray to the middle floor pan next to the drive train tunnel arch.

I'm doing my own upholstery and was wondering if anyone knows the finished dimensions of the seat bottom. Basically, what is the measurement from the frame base to the cushioned top so I can make sure the springs are properly compressed in the front and the back. Thanks!

Setup: .030 over, 77-B cam, dual points crab distributor, dual Holley 94s, 3.5 power valves, 51 jets in front carb 49 jets in the rear, both carbs rebuilt with tested floats and new needles. Currently no air cleaners to tune the engine. I need some help! I recently replaced to power valves...

I have the liquid bulb type sending unit. The bulb goes into the head, the nut then threads into the head. How is it sealed between the free floating nut and the tube? Am I missing a rubber flange or something?

Just had this re-cored and refinished then found out it is for a 60 HP flathead. It won’t work for me, but maybe for someone who needs it for their 60. Core is brand new materials, builder says it will cool better than original, but looks like original. A little bit of pitting in lower front air...

I got this for free, had it recored and finished, but it is wrong for my 39. Can anyone tell me what it goes to so I can list it and maybe get some of my refurb money back? Thanks!

Anyone know where to acquire the screws that go into this piece? Van Pelt lists it as part 3588 going into part 3532. Google search is not resulting in any hits. I purchased a couple dog point set screws with the right threads, but the dog point is smaller than the original. Not sure if this...

‘39 Standard coupe. I see in the Green Bible where they hook to the pedals, where does the other end hook onto? Anyone have pictures? Thanks!

Anyone know where I can get my hands on some Zephyr beige paint for doing my interior pieces? Is it called something else now?

I just installed my stock closed driveshaft into the torque tube and rear diff coupler. When I turn the driveshaft, only the passenger side wheel turns. Turning the drivers rear wheel makes the other wheel turn in reverse and turns the driveshaft. Same for the other wheel. Can someone explain...

I'm rebuilding my '39 transmission. Van Pelt book says nothing about packing the 7025 and 7065 roller bearings with grease, nor does Wired Custom's video. Should they be packed? If not why? Thanks for your help

Is there a gasket that goes between the engine and transmission? Does it need one? RTV it? What do y'all do?

What is the maximum ID a wide 5 drum can be turned before needing replaced?

I removed the torque tube from the banjo rear end. Three of these came out. Can anyone tell me what they are? I can’t imagine that they are an actual ‘part’. Don’t see them in the green book. Any help appreciated

Looking for a crank mechanism/regulator for a 1939 coupe

Looking for a driver's side inner fender. Looking for the 1939 version with the cut out for the brake lines. If you have both sides, let me know. Thanks, Eric

Saw one of these. What does it do, beside what the name says? Is it something worth investing in? Do they do a darn thing? Thanks for any info!