Search results

I have a rebuilt Touring motor with a pretty good oil leak behind the crank pulley. I think it has a modern seal installed. My question is can the seal be replaced with the engine in the car. 600 miles on the engine. Thanks, Bob Giles

New problem this year. Car doesn't start when hot. Good spark, amp meter jiggles when turning over. Never had a vapor Lock problem in the past. Loosened carb filter bolt and had gas. Having gas at the filter bolt, does that mean carb has gas to start. Not even a putt , then all of a sudden it...

How can I tell if this is really a NOS rear fender? I'm going to offer it for sale and I don't want to mis-represent it. Thanks, Bob Giles

Is there a vender selling a replacement wheel well that's wider than a stock '30?

If the rear end is filled to the hole, will it be too much. Book has 1 1/2 pints.

On a Vintage Tour there was a leather back with a cover only covering the top. Does anybody know the manafacture.

Are wood patterns available for a 1930 Coupe?

I have a block that wasn't countered for gland rings. This is a fresh Touring engine rebuild. Should I try and have the engine counter bored for the rings?

Rebuilt engine with 3000 mlles. Presently in the car. Come and drive it. Nothing wrong, just a stock motor. I'm replacing it with a just built Touring motor. Bob Giles Johnstown, Pa. 15904 $2150.00 $1850.00 minus Nurex advance and air/oil filter.

Before Dec, I will receive a fresh rebuilt Touring motor from AER. I would like to find a new home for the engine I have now while it's still in the car and can be test driven. $2150 running right now. $1750 minus the carb, Nurex advance and air and oil filter kit. Engine has about 3000 miles...

Looking for nice Model A trunk at Hershey. Does not have to be original. Bob Giles C4I 25-27 divco100c@verizon.net

Will be in C4I-25-27 Complete set of shocks/ dog bones for rebuild '29 ---$100 '29 service brake cross shaft ---$50 '29 emergency brake cross shaft--- $65 Brake rod set---$10 Repro Thermo quail---$50 Bob Giles

Parts going to Hershey C4I---25-27 '30 transmission minus shift lever--- $150 '29 complete ****** w/ pedals,emergency brake, bell housing--- $225 '30 head---$20 '30 steering box, bad thread have repair thread. ---$50 '29 complete steering column with rods---$75 Zenith carb---$100 Tilly carb...

Armored ignition cable from a '29 Coupe. $25 plus shipping or pick up at Hershey Has cast clamp. Bob Giles divco100c@verizon.net 814-266-2780

Can a piston with no markings on top except for the scrip ford be assumed to be standard. I don't have any way of measuring it.

I picked up a generator to use as a spare. It has two wires instead of a stud. Can anybody tell me the proper way to hook it up.

If it possible to find a rebuild kit for a tilly that has 4 bowl screws?

I purchased a steering box from Randy Gross. Little less than a year went by and it needed adjusted. After several conversations with Randy , He decided to send me a brand new one and paid shipping both ways. This is service way beyond what is usually done today. Thanks Randy.

If water is better, would it be better yet with a rust inhibitor added?

I wanted to buy a "BEST" brand head gasket but it seems that none of the big Model A part houses sell the "BEST" brand. "BEST doesn't sell retail so if it's so good, why isn't it avaible through the normal channels?