Search results

A new Co worker found out I was working on a old junker and asked if I would like a parts motor, I must have raised an eyebrow because he brought it to work yesterday. Kicker while unloading it he told me it came from a early destroyer? Says it had a 500 amp DC Generator and he now runs it with...

I have a new Wiring loom from the light switch on my 35 Pu, and am concerned about it being so close to the exhaust 1/4" can't pull it away and believe I have it tucked as it should be. Have seen exhaust pipes glow in the night but not on this. :eek: Thoughts?

I put the screws in order in an egg crate; Now I just don't know the order! this is the second set of screws I have put in the forward side holding the dash in, and now wonder if they go inside along the bottom, inside seams to have a larger hole? Won't stop the world from turning but would like...

I am installing twin horns and a relay and need to pull a new hot – wire, to the relay should it be protected any ideas what amperage two horns pull? And where would you take the wire? I don’t like adding wires too the battery, nor do several wires on the starter switch post appeal to me. But I...

Is there anything between the front cab corners and the frame, when I removed it I don't recall anything there and hate the thought of it sitting on the frame? included a picture of how close it was before that adds to my confusion. the bolts that go through are long and have springs under the...

I tested the horn before installing it; Failed its going back on a 35 p/u 6V + Ground. When I removed the top cap there were no wires attached it is possible the ground loop was under the cap bolt? but after cleaning the bottom of the solenoid and trying the wires in this position with clips it...

Well this is the most extreme modification I have made to the old truck did I disgrace it or preserve it? I have the intent of using it, not just tinkering.