Recent content by Wooden wheel

Greetings Keith, I removed the small split pin out of the thermostat and made sure the hole was at least 3/32. I have also found that if you take the car straight out on to the highway with out a five min fast idle warm up you will get those problems you experienced. The other thing I have found...

Thanks Rusty

I have been asked to do a gearbox updgrade and need to know if the earlier model top with the handbrake on the side will fit the later box with the handbrake on he side.Are there any other alterations needed to complete this change ?

Greetings JackA, A bit of history re my temp gauge installation. When I purchased the car back in May it was having intermittent heating problems but I was 99% sure it was related to a blocked and aged radiator so put it into my budget to replace the radiator. This was done with a recore done by...

that's one very smart machine, well done, I have never been a real fan of the boat tail design but have to admit you have created great lines. look forward to seeing a movie in the future. Keep up the good work

I have just installed one in my 30 phaeton. tapped the sender into the casting on top of the head leading to the top hose and the gauge under the dash above the steering wheel . The excess tube I coiled up with a cable tie and attaché to the right hand side of the scuttle under the fuel tank...

Greetings guys, Problem sorted. It turned out that the problem was in the small gear at the drive shaft end of the cable. Some one had done a QUICK repair !!!! to the Key type mark on the shaft so replaced this and all go. Very many thanks to you all that provided info

Hi there Mitch/ pa, I have been thinking about it over night and wondering if the gear has worn and by pushing it forward it is locating on a non worn section on the spline. I have located another diff and drive assembly so will pull torque tube off that and see how it all fits together. Thanks...

Thanks Mike but been there done that but it does not give me the info on how the drive gear is held in place.:)

Greetings fellow Ford Barners My speedo on my1930 Phaeton has stopped working and I have found the fault is in the drive gear on the drive shaft. The drive gear on the drive shaft has moved back and become disengaged from the spline. Can I repair this without removing the drive shaft and diff...

Morning to Rock Hill Will. As organiser of the above mentioned tour into the hills I endorse your comments in your first post. I will add that our trips are based on " use and do not abuse" philosophy and I can assure others that our cars will still be around in many years to come. I must add...

Good to have a laugh every now and then., Merry Xmas to you all out there. Mitch/Pa ,you get the big gold star !!

Hi there Purdy.I would agree with you too, not much strength required just technique, Our 30 phaeton will start every time on the third pull up. After reading these threads I can see a number of Model A owners going out to the shed to see if the handle works!!!!! Three safety things I would...

I was asked to repair an impact damaged brass veteran head light and advised to use a very smooth surfaced panel hammer,(I actually dressed mine up with 800 grit wet and dry before hand) and GENTLY work the surface with light taps . Using pipe or rod or a socket on the inside as the others...

During your installation you didn't by any chance catch the short brake rod on the end of the brake light switch and bend it causing it to jam in the part return position? I am speaking from experience!!!!!