Recent content by whiskeyding

Thank you so much. I will look harder for markings mentioned. I looked but knowing they're there I will look again

Hello again, I was on a job and a guy was going to junk a eac Mercury. I asked if I could save it and he said yes. I am now trying to determine if the coil and voltage regulator are 6 or 12 volts. The coil is a yellow top coil. And if all yellow top coils are 12 v I am going t assume the...

This is what I need

Well hello again Ford barn. It has been a long time since I've posted anything, so long that I don't remember if I had ever done so. I have been working on this truck for most of my son's life. He is now ten. It began as a traditional model a V8 project, but somehow turned into a 39 Ford...

Mr Texas I thank you that is the answer. After working on them again , the small clip in the first pic was just flattened. Once bent back the drivers side plate is good. Going to fabricate the ******** arm and weld it on also the spring for part king brake lever. Again thank you Mr Texas

Can I even buy these clips. I've found them for 42-48. But not 39-41 ??? Can I run with out them. Has any one

So hello fellas, in the process of getting my 39 pick up on the road I noticed that the hold down clips are all broken except one. Can these be replaced? I ask because they look like they ar e spot welded ? Should i just use a set of 42-48 that I have or what any suggestions appreciated...

Looking for a piece of frame to repair mine. Usual spot where x member meets outer rail . Drivers side.. Only about a foot long right where it kicks up. Thank you ford barn

I need a couple column drop parts. Pretty much all of them. Cyl. no key is okay. ring with switch nail and on/off lever. On/off plate. cap for the end. bearing and spring for detent. and the two post switch plate and brush. and i think there is a cover for that to? thank you for...

I just took mine apart. If you push the brushes all the way up against the springs until they are pushing against the side of the brush they will stay there. Then once everything is assembled you can just push them down to the amature and the springs go where they need to be.

Need a pass. side flathead merc water pump with to mounting tabs. not the 45* mounts. buildable core. have wide belt merc pump i'm willing to trade