Recent content by wbs

Thanks for the reply, i learned a lot. Trial and error taught me: stamped bended side down. 31 roadster in parts and my inexperience. the a161 had a straihght top but i noticed that the lid was slightly bowed out , so interference upon opening . when i madt the a161 curved out the a161...

hello about what synders calls a 'curved interior panel ' a-161ab '. not sure what edge goes up; it has a rounded edge and bended edge. which edge is attached to the rumble seat riser? thakns

thank you you are always helpful I am thankful for your advice

heard these --only help someone else---Bottom Cushion Base: Roughly 38 to 39 inches wide at the front, tapering slightly down to 36 to 37 inches at the rear. The depth (front to back) is approximately 17 to 18 inches.Backrest Cushion Base: Fits onto the inner skin of the trunk/rumble lid. It is...

typo seat not set thanks

hello does anyone know where I can find dimensions length width and depthof back rest and seat? thank you

.........................................................

in regard to mr serrano question: knowinng the right to left measurement , I got my car in pieces and i'm missing the wood anterior piece that goes between the 2 stanchions , so I am going to have to make a piece and like any restorer try to do the best that I can ,I would want to get the...

thank you gdmn852 and all who were kind enough to reply now what I would like to know is the distance from left to right top of stanchions I can tell it is somewhere near 46"

thank you cw just what I wanted to hear

thank you for your reply the reason that I think my car is delux because it has the continuous bent oak bows. i'm not sure if that thinking is correct. and by the way , your car is beautiful

thank you Mr Serano I appreciate your help

hello I don't the type of 31 roadster but I think the rough distance is between 46 and 47"

hello please excuse my not knowing proper names 1- does anyone know the distance between center points of stantions? 2- in the past there was a substance used to fill defects in curved bows. I cant find that post. the post said it would hold upholstery tack. does anyone remember that...

thank you so very much mr gdmn 852 exactly perfectly clear and just what i needed.