Recent content by Wars37

Just bought the car I have a no start but noticed the coil was hooked up backwards neg was hooked up to positive supply . I cleaned the points but still no spark.

How do you check ohms ?

I have a 37 flathead model 60 with external 6v coil and I want to replace it . Can i use any coil as long as the + wire goes to the distributor? I have a ballast running before coil. Also I want to change my condenser ,can I use any ford condenser ? Thanks for any help.

Chasing a no start 1937 Ford 6 volt model 60 . I have very low spark so I relaced the coil -no good ,- tested the condenser with ohm meter -good , Pulled the distributor off to check points and half the cam keyway on distributor is missing . It appears to have been like that for a while...

Where can I buy a 6volt ballast resistor ? Most sites don't specify 6 or 12 v. Are they all the same? Thank for any help.

Just picked up a 1937 humpback and need a good source ford parts such as floors, water pump, belt, interior and maybe brakes. Thanks for any help.