Recent content by WarbirdPhotog

When I get some free time (not sure when), I might look into building an app just for Ford Barn, if you're interested, Ryan.

I'll be there!

Just an update... Tapatalk appears to be working again! Thankfully!

That's a cool battery! And a lot easier to build than what I did (no 'star texture'). But I'd need all the measurement specs of the actual battery to build it. I was lucky with the '40 Ford Battery that the Early Ford Parts Store had one I could borrow for a few weeks to study and measure.

Thank you! I enjoy creating things like this. Although it was a headache at many points, it was worth it!

I wanted to post a comparison of the real battery and my 3D printed on. As mentioned, at some point I'll head back up to the Early Ford Parts store to borrow the real battery again and get some side by sides.

Hello, thanks for the measurements. I actually mimicked the tar texture, to a degree, using some textured 'grain' paint. Using actual tar is a bit beyond what I would want to do, especially when you can mimic it. As for the gold, I actually tried it with a rubber hobby roller, funny enough...

Okay, here's the BIG update! I meant to post it a two weeks ago when I actually finished, but life has been crazy. The 3D printed 1940 Ford Battery is DONE and ready to be installed (well, once the car is ready). It's taken about a year of on/off again work, lots of failed/wrong prints, lots of...

Thanks for reaching out to them! Hopefully it gets back up and running soon.

Not sure who the board admin is, but I'm not able to access the board via Tapatalk anymore. I get 'Network error, please try again later. (get_config)'. Uninstalled/reinstalled Tapatalk, but it appears to be an issue with the forum rather than Tapatalk in this case.

Big update: The main box has been glued, sanded, primed, and painted! Starting to see the light at the end of the tunnel. The side panels were a huge pain to 3d print. Aside from the size being too large for my printer to handle in one go, I had to split them up into 3 parts, then put them...

That link doesn't have the cables with the terminal clamp on one side, but after looking I found the same company also has a similar thing where you can pick the terminal clamp size and length. I'd prefer one with a woven loom on it, but of needed I can go this modern route is there no other...

Hey all, does anywhere sell a correct longer 1940 Ford negative battery cable for a proper terminal 5v battery so the cable goes around the hot air tubes to the solenoid? I realized the one I have from CWMoss (their only 1940 neg battery cable) is too short. This sort one probably works for a...

Agreed to most of this. I've seen many parts made cheaply that are not even close. In the WW2 Jeep community these many instances of this when it comes to body panels. So far, the set of these reproduction guards (I got a set from Drake that arrived last week) are lining up and looking good...

The ones I got seem to fit just fine with my original bumper. Perhaps the new manufacturer has better tolerances?