Recent content by Voycey

Hi All Apologies as this may have been covered in earlier posts. I suspect the horn button is the problem why the horn is not working, it was working previously. The Horn on my 36 has 2 wires going to it , one is active constantly , the other I guess is to ground. The horn works fine hooked...

Thanks drolston , Yes all wires run from the indicator switch , to both rear tail lights , and from brake switch to indicator switch. It looks like I just need to run another wire from the brake light switch to the other tail light ? and disconnect loop at rear. The other points is with the...

Thanks Zeke No there is only one wire from the brake light switch to the rear right tailight then loops across to the left. Do I need to run a separate wire from the switch to the left tail light then cut the loop wire ?

Hi All Help needed , Just hooked up 7 wire indicators to my 36 , 6 volt system. Park lights and stop lights both flashed when turn signal activated. Park and tail lights feed loops across so not sure how to isolate the indicator feed to each side. I disconnected the feed from the steering...

Hi from down under.. I finally , while renewing the carpet in the front and tidying up front floor panels had a look at the chassis / body number stamped on the transmission cover. I came up with *C18VF11* not sure but the C is for Canadian , car is from NZ , 18 the model ? it is a deluxe 4...

My 36 Sedan , Canada to NZ model has the same setup as KIWinUS

Hi All Refitting my Grille on the 36 after a quick lick of paint , Should there be welting between the grille and fender as pictured as there was none before removing ? metal on metal doesn't sound right, also are there specific bolt sizes to attach the grille to fender , mine was missing a...

Hi A shot from the back showing the lugs , dont force the key , maybe spray crc down the lock , once you have the outer surround off , carefully pry the front enough to get some spray down on the lugs as they do get seized up at times. Good luck

Hi Apologies for jumping on this post but are these available anywhere as a repop.

Hi Guys Any suggestions / recommendations for a replacement 6 volt wiper motor for a 36. The one I have is playing up , it appears to be a Japanese motor Mitsuba 730 , no idea what it is out of. It mounts behind the panel above the windscreen , the Macs and others I see seem to big to fit...

Hi Henry Attached are photos of how my cover attaches, the lock is held onto the tyre faceplate with a circlip and once you unlock it the whole faceplate comes of once the tyre ring has been removed.Not sure the locking mechanism should ever come away from the faceplate as in your photo.

Thanks following all Instagram voyceyv8

If you get to Masterton visit Pointons Car Museum, Magoos Street Rods and Gasoline Alley in Carterton. Shoot over the hill to Wellington to Southwards Car Museum it is a great set up, 250 cars including Marlene Dietrichs 34 Caddy.

Rays Dodge Coupe , it is s beaut and mostly restored by him. Twin side mounts really stands out. His woodgraining is an art in itself.

Ahipene Mercer , great guy , I was his neighbour and helped him drag that Dodge back from Dunedin in the 90s , he helped me drag a trailer load of 36 parts from Tauranga . We both still have our cars,