Recent content by Unshined2

Hopefully that rear thrust washer is stuck on the backside of my timing gear. The 59 Ford Shop Manual doesnt show a nice assembly pic like the one you showed....

Thanks for those pictures!

Did a search and I couldnt find any answers, so Ill have to ask here on the board. I changed the timing chain on my 59 292. I installed the gear, fuel pump eccentric, spacer, washer and cam gear screw. And the fuel pump eccentric is still loose. There is a .045 gap with screw bottomed out on...

They look the same, but the horn button. I have a 39 Mercury horn button, but am wondering if it will swap into a 40 Ford wheel without modification.

Can anyone tell me if the 39 Mercury steering wheel the same as a 40 deluxe. If not, how much difference is there? They look awful close to the same.... Thanks

33-34 Fordor body, with all doors and garnish moldings....

To the top. Thanks

Looking for a 1939 Mercury speedometer to fill the hole in a Mercury dashboard. Thanks!

Just wondering which transmissions I can use behind the Flathead in my 53 F100 panel. Will the later light duty standard 3 speed from the Yblocks work? I'm almost positive it was just a light duty in there from factory. Don't know for sure though, because the engine is still there, but no...

I'd just like to get the engine running on my '59 galaxie. The engine is a 292 with OD 3speed. Someone swapped in a straight 3speed and the wiring is kind of a mess. Can anyone tell me what this resistor looking thing is next my coil. It is wired to the distributor side of the coil. Is it...

Excellent---Easy find. Thanks much

What are you folks out there running for fluid in your Merc-o-matics? I have a 52 Mercury with a Merc-o Matic that hasnt ran for at least 25 yrs. would like to start the car and just drive around a little, be able to drive on the trailer, etc... Thanks

Thanks a lot guys. exactly the info I was looking for. One more question, is the 57- 58 convertible frames the same as 1959?

I have a 59 Convertible with a bad frame and have found a 57-8 Ranchero frame for sale. Can anyone tell me if they will interchange. Or if they are a close match, what changes have to be made? Thanks in advance!!

The tube (#01902) bolts to the housing (#8014), which in turn bolts to the bottom of the front fender below the headlights....if i remember correctly....