Recent content by trubble

Good point all. Those danged old inventions need attention in all areas.

I have the same issue. My quick fix is split a straw or tube and slip it over the cable wire. This stopped the short for now but I'll need the new cable. Question is "which cable?". I'm seeing several types. What say you?

Wondering why one or both of the national organizations doesn't have a committee to review of rate reproduced parts.

I've done similar. It is very gratifying.

Thanks Fellows for your thoughts and advice. I can't see any chunks or is anything bouncing around in the bell area. I am resigning myself to the fact I will be removing the trans and replacing the out of whack parts soon. When and if I find anything out of the ordinary I will try to submit a...

I checked the bearing and it will spin. When I press the peddle the throw out bearing will move all the way in. But the problem remains, the pressure plat fingers are not returning to the in gauged position. and the disc is still in contact with both the flywheel and pressure plate. Is it...

Yes .The fingers are remaining in. The rest if the parts are doing their part. When I adjusted the linkage I think I went most of the way on the rod. Thanks Flamingo.

I have been slowly getting this car drivable sense last July. The motor has been starting and running ok. I have driven it only a few miles. Under ten anyway, So the other day on a test run I noticed the clutch dragging. No sweat, I crawled down there and adjusted the rod and gave it the start...