Recent content by trestles126

Everything new or rebuilt.*with probably 4500 miles on it since rebuild 15500 obo email me for inquires tresles126@yahoo.com All steel Ford body with a few patch panels. *They were in there when I got it so I left them.*Doors open close nice but it has some rust on the inner door down...

Everything new or rebuilt.*with probably 4500 miles on it since rebuild -All steel Ford body with a few patch panels. *They were in there when I got it so I left them.*Doors open close nice but it has some rust on the inner door down low.*Sitting on Model A frame that has pitting but adds to...

Lookin for rear roadster body want to convert my Rpu into a roadster possible trade plus cash for my good condition Henry Rpu back half

My banger rpu had a leakless pump on it ( bought the car running learning the banger ropes as I go) I greased the rear fitting wrong and blew the seal Long story short I took it all apart and found the shaft was a bit messed up. Want to rebuild it or just buy a hole new pump Been looking on...

im leaning towards the pump mentioned above

any input on the snyders leakless water pumps. there are 2 types on there one with the packing nut and the teflon seal for backup in the rear nut as well as a pressed in sealed front bearing and the other is the non packing rear nut. thoughts opinions? i run straight distilled water and flush...

-All steel Ford body with a few patch panels. *They were in there when I got it so I left them.*Doors open close nice but it has some rust on the inner door down low.*Sitting on Model A frame that has pitting but adds to the look without compromising strength. Bed is straight but not perfect but...

any good books out there for banger motors? just picked up a late 40s RPU with a fresh banger in it never been around them would like to read up on um and have a book around for when it comes time to do maintenance and up keep. some specs Model A four cylinder motor. Bored .125 over (214 c.i)...