Recent content by toddjg

I'm interested no rust ? How about shipping to south fl maybe with gray hound

my continuing project 1950 tudor

bubba did a vintage mallory dual point for my 8Ba real nice works great it was in real bad shape.

So what is the best way to repair this? Without taking panels apart.

I guess I didn't relize that it was a t shape I just want to make this area look right. So do I shape some sheet metal into a t shape and hammer it into place?

I started removing the paint, bondo,fiberglass, chicken wire and window screen off my car. Being a shoebox its got its fair share of rust. a former owner had tried to do some custom work and trimed the tops of the quarter panels then filled them with bondo I want to restore this custom work...

used offenhauser 3 carb intake manifold with offset gen. bracket elbo and two thermastat housings.

ok i figured it out the line coming from the fire wall had a fitting on it that i was using to attach the rubber hose to run to the fuel pump. this fitting is what is left over from the original fitting from the rubber hose that came with car. i am using a large hose fitting on pump for the 3/8...

ok i got fuel line from pump to a jerry can in engine compartment. and so far no bubbles i guess i need new hard fuel lines and maybe tank or at least a clean tank.

ok line is clear from tank to pump put another pump in and still has air bubbles and quits running. car runs until carb is out of gas. next i was going to run fuel line to pump from gas can to elimiate tank and fuel line.

i think there might be a hole in the pump bladder. since i don't see where else there could be air getting in.

its still finding air bubbles trying to track them down at least i'm on the right track.

ok i just blew air from tank to fire wall line pump disconnected. fuel came up thru line. i then hooked glass bowl up to pump and found a change from before. before air bubbles were coming in to bowl now no air bubbles at all i guess there was air in line or a clug that trapped air. so far its...

now its not getting fuel at idle either i think it is dirt i had dropped tank out before and cleaned it i guess there must be some small bits of dirt that have collected.

it has to be something simple like that.