Recent content by Teich

I use non ethanol gas #1. When I redone engine 1948 239 (52) engine used "corn" gas worked ok but garage always smelled sat for few days had to pump fuel to carb, exhaust smelled. Tried Premium fuel ran better no smell didn't evaporate as fast costs more I think its worth it. Live next door in...

lots of spray on window cleaner works nice and easy to clean up Laurie

Before you adjust the cable you should adjust the brake shoes at each wheel, then adjust the cable Then it should work,the newer cable is it the same length as the old one if the inner cable is to long in relation to the outer cable that will be a problem Laurie

The center of the hub, the space between the races should be filled level with the race. This from an IHC truck repair manual it is to be a reserve that comes out as wheel assy. turns. Can't say if works or not but never had a failure, I guess it a Safety feature, Laurie

Above is correct adjuster to the pitman arm, the nut will face down on both ends, when you steer to the right the drag link gets real close to the radius arm. Laurie

I don't think you can adjust the gauge, tried that-- had a gauge apart and a sender, there are adjustments in there as well, in the end never got any better. To get a gauge closer try using the sender from 1957 Ford truck with a gauge it may work if not get the gauge as well (change the face and...

Do what Old Henry does, but add a short piece of rubber hose, then you don't need the finger insert hose squeeze the bottle ( rotate the bottle up first) Laurie

To get the seal out use a bar with a bend on the end, put in past the seal and tip outer end up or down to get at the seal to drive it out,or use a lady finger bar to pry against the bearing on to the seal pushing it out. If there is only one seal, ie the inside one, the bearing runs in oil from...

Use the counter balance lever on the lid, then install a lever on one side which is lower than top of lid, now you could lift it up but not over your head. Adjust the balance so it just a slight lift, then make up a latch if there isn't one to keep it closed. Laurie

Could it be an Auto light 9000 painted silver with one green pilot light? If so have lever assy. Laurie

If this redi sleeve is a thin one it should come in a metal cup this is a driver, DO NOT heat, it is meant to be pressed on using the cup as the tool. The part on the front of crank where the seal ran is removable, if that comes off easy push the redi sleeve on to cover the worn area, you can...

Bought water pump kits there this spring ph. 780-963-7334 Laurie

leaned out, both carbs came with '94' size throttle bore both had the nozzle bar that was tall at the front, then to mess things up just got a 94 as stamped on the rear ventures are same as 94 so it must be, but this one had the tall front nozzle bars and 52 jets was on a 1953 EAB in F250 truck...

Have a 1 1/16" came with 57 jets, tried one before put in 52 jets to lean went good till the bog set in! Laurie

OEM is as 19Forty says, had the same problem with one of Bubbas dist. with a Pertronics it will make a knocking sound, just take the gear off and shim it really didn't want to ship back dist. still works great 3-4000 miles Laurie