Recent content by teedog

is it a good idea to coat gaskets with sealer on both sides ? im using cork. thanks for any help, mike

that's the one, need allen wrench to remove it

looks like a 8 sided one except it is a hex, I was going to take both inner and outer nuts to get re chromed. I got his tank and fuel gauge back in the 60s out of a junk yard. any place to get an original inner nut? thanks

I have a 1930 and was wondering about sight glass nut, the one I have is a hex nut but only see ones with 8 sides and don't look right. any one know what I have? thanks for any input, mike

glass setting tape, berts in Colorado. part 45512 .75 foot

Im going to give berts a call in the morning. Now that i remember i never did use a spring spreader WHEN I INSTALLED IT YEARS AGO. Will i need one? Thanks for your input, mike

TOM , bottom of axle is about 5/8 inch above the bottom of rad pan in the center. also shocks were installed in april. so no axle is showing.

my tie rod and drag link are straight. I checked clearance this morning and I cannot slide a sheet of paper between. I still think its the spring.

I will replace front spring and any other parts that need it. thanks,mike

thanks wmws shackles are about 3/16 from top of axle. think my spring is done.

any one know what clearance should be between drag link and the top of the tie rod , mine looks like they might be rubbing or close to it. thanks for any help. mike

Re: Stainless Mufflers Question if it comes ups it will be damaged in freight

cw, I wonder if you could do me a favor, and take measurements of height, length, and thickness of both top and bottom cushions. I would appreciate it. thanks, mike

I was there in the early 70's late 60's I might still have some dash plaques around

forgot to include berts, try them first