Recent content by stegomo

I have an inertia switch that cuts power to the pump and ignition if the event of an accident

there is a 3 part video on this on youtube using saturn vue power steering into a shoebox

I'm looking for the steering shaft for a 1590 ford sedan, don't need the steering box just the shaft and doesn't need to be intact. only need the top 2 feet

Any suggestions on how to clean up aluminum heads and a coating for them?

Thought i had the motor done, then i found these parts

Not applicable

Managed to get them on and pistons in. ( I asked Lordco for a price on Hastings rings for my engine $519.00 )

They are Mchenry rings for a 4 ring pistons

Starting to reassemble the engine and upper oil ring has 4 pieces but when I put them on the rings don't want to compress due to the inner piece holding them out

there is no mark on the piston tops,There is a vertical slot cut in one side of the skirt between the two oil rings should it go up or down?

I paid $40 for one

Thanks I will check it out

I know the piston pin is offset but there is no mark on the pistons to indicate which way to install. there is an oiling slot on the skirt, does it go up (intake side ) or down (exhaust side )?

Anyone running an 8CM camshaft in an 8BA or thoughts on the idea?

Looking for a set of four ring 239 piston rings with 5/32 oil rings