Recent content by slantback37

I have a 72 truck rear end. I am using the original handle to pull on the rear drum brakes.

Almost done with a 1937 Tudor Sedan. I need help installing the handbrake. I am using the under the dash handle. I have the cable that goes on the handle. At the other end of the cable is this elongated part. I have cables from the rear drums up to a plate that holds the cables. I also have...

I bolted it to the firewall. there is nothing on the other end, but it is holding tight. I am going to replace the bolts I have now with fine bolts and star washers. Thanks

There are no holes, but maybe I could rig something up to hold that bracket tight. Thanks

Thanks for the picture. Now on the handle end. Where under the dash would that bolt to? See the person I bought the car from years ago was going to build a gasser. Under the dash most everything was missing except for the square steel conduit that runs from one end of the dash to the other. I...

I can bolt it to the top of the firewall, but if there was a bracket that goes under the dash. Well that is long gone. The only way to hold it down there now would be to use a hose clamp that would go around a steel square conduit that was put in before I bought the car.

I found a couple of holes on the firewall that might work, but then the other end sticks out by 4". If I could see a picture or 2 of where it mounts. It sure would help. Thanks

I lined it up with a couple of holes I found under the dash, but then the front sticks out by 4" There is also no holes in the dash for mounting the handle. The hand brake was laying on the floor in a pile of other parts when I bought the car 20 years ago. I would like to use it again.

Hi. I have a question. I have a original hand brake for a 1937 Tudor Sedan. Does anyone have a picture of where it mounts under the dash? Thanks

Thanks.

Those will do it?

I have a couple of those for the hood to the filler panel. What I mean is the plugs on the side of the body that prevent the filler panel from rubbing against the body in the rear of the filler panel.

What are those plugs called that go on both sides of the cowl that prevent the fender, and filler panel from rubbing, and where can I buy them? Thanks

I bought them from fordv8j. Thanks

I have ads out for them. Like I wrote before. I found someone that has bows for 30's and 40's. I have to measure from side to side to get the measurements. I will have to go back up to the college to measure those indentations where the bows sit. Then this person will measure his bows from tip...