Recent content by robby

check make sure your use a 12 volt solenoid we asome you went to 12 volt if you have a 260 v8 depend on the solenoid three post or four one battery two starter and three the key normal on a 6 volt system. 12 volt same with a 4 post one battery two starter three key and four to the...

on my second 51 p u i have it got a 3 sp as well im looking into putting a 1950 mercury 3 sp od trans. i hear very little changes to be made. like trans mount and drive line it use the same trans spacer between the block and trans same clutch hook up so i going to look into this it. i...

4 yrs ago i used a 1970 ford 1/5 ton 9 in 3.25 in my 51 3 sp i cant burn the tires but it give me good speed at lower rpm bolted right in. use all stock parts. all i did for shock was reverse upside down drilled hole to drain water but no problems

i use a 1970 1/5 ford 9 in rear axel bolts right in i flipped my shocks upside down so the upper part of the shock tube would clear the frame drilled holes into the the tube drain any water works just fine

thanks i follow up on that rob

hi looking for info on swapping a 1951 f-1 3 speed side shift to a 1950 mercury 3 speed o-d any help would be great thanks

i have a m-h 51 f-1 what is it you need info on ?? i send you some of mine i have a front axel i selling if your looking for a spare or in need of one thanks robby

here a 1949 ford coupe 85% done 3 speed over drive, rebuilt flathead mercury v 8 with cast iron header, 4 barrel carter all new glass, polishes all side trim, trim around windows, rear 2 inch lower block in the rear, new skirts ,14 rims with 4 in white walls bias tires, flush out fuel tank new...

looking for 1949,50,51 ford marmon herrington 1/2 ton truck info trucks that use a LD-7 front axel thanks rob

hi i was wondering on the 97s im looking for a dumming 97 for a v8 club display motor it can gutted it only for look only thing i looking for is the card with the outside choke throttle levers are to make it look stock no need for butterflies, choke plates, floats, jets,valves ect. striped...

does anyone know where i can get the hood badges restored as well as the vin number tag ,plate,plaque,badges i have several pieces to be restored vin# badges hood, dash, and door badges any help would be great robby

hi i was wondering if some one knows of a service in restoring vin number plaque id, name, model numbers plate or plaques that are usually mounted on the firewall or glove box i got a marmon herrington ford truck thats has 7 plaques/plates to be restored thanks for your help robby

it been awhile but when i bought my f-1 m-h from jeff i saw this truck in person it a complete truck great start for a restaration dont part it out good start for some one robb

stu that great you got a hold of him he had a 49 f-1 m-h panel 51 f-1 m-h truck and a 52 m-h f-3. i had bought the 51 truck m-h. a guy in kennewick washington bought the 49 m-h panel. he call me about the f-3 and i pass on the info here. he a very nice guy full of information i email chuck...

hey stu i dont have any photos on the f-3 that for sale in mt.vernon but here his number name jeff and number is 206-334-2206 un sure of price but contact him robby