Recent content by ricspicup

in the midst of a 37 ford pickup rebuild . motor is 21 stud flathead with Mallory ignition, 4 in crank, 20 over bore , cyclone heads and thickstun intake dual carb motor rest of pick up is stock except converted to 12 v neg grd. question is what jetting would I use and how do I determine...

make sure that rear bolt on the upper side is removed. if its been on for a while may just need some extra coaxing . the rear seal between pan and clutch housing can make the rear stick more than the rest of the pan

I m in midst of a renovation 1937 ford pickup decided to change to 12 volt neg ground im keeping generator just changing it to 12 volt it has upgraded distributor with 12 volt coil the fuel sending unit is 12 v and the bulbs will be changed to 12 volt ie tail /stop light and...

Not sure how to upload pic to this

I have changed backing plates on a 37 1/2 ton ford pickup to 39 to change to a hydraulic braking system however I cnt get the hubs to slide over the pads even after adjusting the cam adjusters on the pads I have new cylinders on any suggestions im pretty sure 37-39 take same...