Recent content by pete1128

  1. P

    Hand crank

    The bracket on top of the front crossmember has a pin on the bottom that is not in the center of the bracket. When I restored my 29 roadster I couldn't understand why the crank wouldn't reach the engine as everything else lined up perfectly. I had to replace the radiator a few...
  2. P

    TAMS Model A Parts

    I have done frame off restorations on 2 Model A's over the past 12 years or so, and have used Tam's for most of the I parts needed. He ships packages daily and being 50 miles away from his place I get them next day. He may very well be in Carlisle or Hershey, I know he goes every year and...
  3. P

    Squeaking near front crank pulley

    I had the same squeeking noise after completing the restoration on my 29 roadster. It would go away when stepping on the clutch leading me to think it was the throw out bearing. I then realized it was coming from the front of the engine, removing the fan belt didn't make it go away. A squirt...
  4. P

    sloppy steering

    After rebuilding the 7 tooth box on my 29 and trying several times to remove the slop in it I called Randy Gross and ordered a steering box from him. He had one right in stock, I mailed him a check and it was here in NH a week later. It is a nicely done F100 conversion, all complete with new...
  5. P

    Fustrated at Snyders (Vent session)

    Tams is located in West Boyleston Mass. which is right next to Worcester. Its a family run place, Joe and his daughter Joanne do it all. They have a lot of inventory, competitive pricing and customer service is top notch. I am 50 miles from there in Derry NH and if I call them before 5:00...
Back
Top