Recent content by PatrickTA

So I’m working on a 7 tooth steering column. I have alignment problem between the upper and lower bushings of the column. I was thinking of cutting the tube about half way thru. Which should allow the tube to flex and should be able to realign the bushings. Then weld back up the tube...

Hey all. I know this has been discussed plenty of times, however I can’t find any plans/measurements on what needs to be done to make a roadster top fit onto a an open cab pickup. 1928-29 year wise. Anyone have the measurements/plans you’d be willing to share? Thanks Patrick.

Hey all Curious if anyone has or knows of anyone who has any parts for Mallory distributors. I have a duel point distributor I need new points, condenser, cap and rotor if possible. I have the Mallory part number for the points as well. Number 24205 Thanks Patrick Musante

Hello All Curious if anyone has either original or copies of Advertisements for Model A Open Cab Pickups. I’d love to get an ad or two. Please let me know if anyone has any. Thanks Patrick Musante

I’m looking for a good used set of ring and pinion gears. Thanks Patrick

I need one axle shaft in good reusable shape. If I need to I’m willing to buy them as a pair. Thanks.

I am working on a 32 Ford Roadster that was turned into a hot rod back in the 50s. customer wants a speedometer. I’m looking to put a mid 30-40s speedometer in it. (Let me know if anyone has one for sale) The drivetrain is stock. Stock rear axle, model b engine. So the driveshaft has the gear...

Shims should be set when the engine is Align bored. What I mean is When I Align Bore the engine to size, the shims are installed. www.patsrestoration.com

Anyone have a good used Ring and Pinion they like to sell? standard ratio. Thanks Patrick

Hello I’m probably at you driving limit, as I’m located in Monroe, CT but Feel free to reach out. www.patsrestoration.com

Hey all Just looking for a little advice. I am going to install a 3rd main oil seal In a Model B engine. The instructions say to pressure check the main bearing with oil to 10lbs. I’m wondering what the best way is to go about that. Thanks

I’m working on a Model B Engine, and I’m curious what your opinions are on having the crankshaft ground for an oil seal. Also if you choose that route what seal is recommended. I’d prefer to leave it stock. Just want to make sure it doesn’t leak too much oil out the 3rd main.

Hey all I am looking for a speedometer for a 1932 Mode B Ford. I’d prefer it I’m working order or least needing minor work. Thanks

Hey All I am looking for a speedometer for a 1932 Mode B Ford. I’d prefer it I’m working order or least needing minor work. Thanks

Thanks for the photos! I’m not sure what style i need yet. I’ll look at the bed later tonight. I’m guessing the later style. Judging my guess of the firewall stamping date 12/14/28