Recent content by OH37FORD

Coupe has been sold. 12/10/2017

1937 FORD COUPE 85 H.P. UNRESTORED AS HENRY BUILT IT EXCEPT FOR 39 HYDRAULIC BRAKES COMPLETE MINUS RUNNING BOARDS PRICE INCLUDES $3800.00 IN NEW REPRODUCTION PARTS RUNNING CORRECT ENGINE FOR 1937 IN CAR WITH EXTRA COMPLETE 85H.P 1937 ENGINE...

Thanks for the information. Tom

I have a trim piece that i need help to i.d. The question is, front or rear and body style ? The trim piece is 18" long across the top thanks tom

Thank you, your picture is a big help. Tom

I think I have a lower pillar bracket for a 35 -38 Convertible Sedan. Part stamped with 48-74318? Last number on part was drilled through. Thanks, Tom

Don, Thanks for the pictures, and the time to reply. Question answered. Tom

It came with a 1937 radio that i bought years ago. It measures 5 1/4" o.d. X 2 1/4" tall made by philco. I have a radio service data sheet showing the receiver, control unit and speaker. The picture of the speaker shows a different style.

Thanks again, you have been a big help.

Is this the correct ashtray retainer for the back of a fixed front seat in a 1937 four door sedan or convertible sedan ??? The inside opening is 2 1/2" x 2 1/2 " Thanks

How can you check a amp guage that is not in the car. Thanks

Part is used, with hardware Buyer pays UPS shipping

Would like to know if part# 81A 9002 replacement gas tank will work without any modifications,other than changing the sending unit. The body will be off the frame and will be using the original filler neck and hose setup. Getting a yes and no answer from different suppliers...

It is a 91a assembley

I have installed a 39-40 brake / clutch pedal assy. on a 37 ford. I am using the 37 trans. with the stock lever on the clutch cross shaft. The clutch pushrod from the pedal assy. to the lever is offset. Will going to a 39 clutch pushrod and cross shaft lever correct the offset problem? Thanks