Recent content by nbaum

As an update. A&L does not have this part. I purchased the escutcheon for the window crank for a later cabriolet. It fits quite well. I ground off the little tabs that would normally press into the upholstery. It stands off the top by about 1/8" so you can see some black. I think if I reshaped...

I have the rubber seal I just need the escutcheon. I keep trying to call A&L but get no answer. Any other suggestions on getting these?

I have a 1930 Cabriolet and I need the small escutcheon that goes on the top end of the landau iron between the top material and the landau iron. Need both sides and I don't see them at the usual part stores. Any suggestions on a source would be appreciated.

Got it out. Thanks. The padding is fresh and the fit is tight.

I have a 1930 Cabriolet with adjustable seat. Is there a storage space under the front seat? My 29 Tudor had it under the back seat but I don't see how this front seat lifts up.

I need a rebuilt carb for my February 1930 Cabriolet. Who has the best rebuilt carbs for sale?

We are getting closer now. Need a couple more things to be complete. The shaft hole size is not shown on the service bulletin page. I think its 7/16" dia. Also it does not show how far up on the frame the center lines of the holes are drilled. I think its 11/16". Thanks for every ones input.

I have a 1930 Cabriolet. It was restored with a new windshield frame without the holes for the electric wiper. I have the proper original electric wiper but I would like to verify the hole sizes and dimensions before I screw up a $900 windshield frame. The dimensions below are what I believe to...