Recent content by mumbles89

I will consider that and ill price out places. but I don't think the block is shot it still runs and driver with no overheating or smoking issues. I got it from the original owner who seemed to not drive it super hard.

That sounds ideal for tuning and dialing things in I'll have to look into the o2 sensor for tuning i hadn't heard of doing things that way.

I'm looking to probably spend around 1200 to 1600 on the engine. That's what it cost for my sbc 350 in my model 48. I'm looking to have a shop clean and inspect it see if there is and cylinders that need resleeved and have them do the valves and springs and ill assemble it. I'm not chasing...

I'm going through planning my build for my stock 302. I am looking to give it bump in hp and wake it up. So far I'm planning to swap in a xe256h cam keep the original heads but clean up the casting and put slightly oversized stainless steel valves in. I'm going to do all the typical upgrades of...

the model a also has more of a curve and isnt as long

I'm looking for a trunk support arm from a 1933-1936.

Im trying to track down a trunk support arm for a 33-34 or a 35-36. it looks like they discontinued reproduction of them or they are sold out on all the ford reproduction sites.

Im looking for a original or new windshield crank out regulator for a 1935-1936 ford sedan.

Hi I am looking for a windshield regulator for a 1935 or 36 that is in good working condition.

Ok thankyou ill give him a call

I am restoring my 1935 ford coupe and im working on the interior and all the wood that is in there needs to be replaced. Ive been looking for wood kits for the 1935 and i remember seeing one a while back but now i cant seem to find it does anyone know where i might be able to get a wood kit for...

ok ill see what they say thanks

Hey im building a 35 5 window coupe and i have a sbc 350 that is going in it and im curious what the best distributor would be for the setup that isn't pushing 300.00 i was was told about a pertornics because iwould give it enough clearance because of the firewall but im not sure my dad had a...

sorry that was 50 1/2"

Im trying to upload some photos from photo bucket. I did remeasured and it was at 5 1/2. At the kingpin. How much do the used original axles run? http://s1029.photobucket.com/user/mackenzie_clark2/media/Mobile%20Uploads/IMAG43091_zpsmk52j0u4.jpg.html?sort=3&o=1