Recent content by Leon

Use the plastic endcap from a grease tube. They fit perfectly without the need of any clamps.

I have a set of Fulton clamp-on brackets for wind wings that I would like to use on my 30 Murray body town sedan. However I need a blueprint or an actual size template for the glass. If anyone can help I would certainly appreciate it.

I use your method for adjusting the front brakes ( it is quite easy to remove the pin from the brake rod clevice) but I can't remove the pin from the rear clevice rods. I am on my back like a contortionist and I just can't remove the pin. Is there a simpler way - is a lift necessary? I must be...

It appears that the overflow tube is too long ( sticks up too far ) and that is why the radiator cap hits the tube. I bet that's why it broke in the first place.

Sunday is Mothers Day - very bad choice.

Oops used ocmafc.com instead of .org Thanks for straigtening me out

Tried to access the Orange county mafca site, but the domain name has expired. What happened? Wanted to review some of their tech articles by Tom Enders.

Seeing a thread or individual post that you want to remember or go back to requires using the search function ( which doesn't always get you to the post you want). If possible, it would be a lot easier to jot down the page number where the post or thread occurred. Currently if I see something on...

Sounds familar - last Year I bought a 31 coupe with a pop out switch with only one key - the key is flat on one side ( no groves) the local locksmith said " no problem - I can use a key with groves on that side " he made a key that works - he used a hillman key blank # IL8 Hope this helps

When applying Peel and Seal on the cowl area of my coupe, is it better to apply it in strips (like the expensive dyna? ) or should the entire area be covered? Also I was then planning to the cover the same area with Lowes foil wrapped bubble insulation. Hopefully someone has experience in this...

Yes - horn & lights work.

Am using the same one that was on there before the rebuild. Everthing looks perfect before I put on the light switch body, - I even tried a different light switch body upper half but it made no difference.

When I attach the light switch spider, spider spring and spider retainer on to the light switch rod, the horn button/light switch handle is flush with the top of the steering wheel. But when I attach the light switch body and bail, it pushes the light switch rod up so that the horn button/light...

Take a head nut and cut it lenght-wise with a hack saw. Cut it thru to the center, screw it on the stud then take your vice grips and clamp them tightly on the nut, make sure the slot in the nut is not against the jaws . This allows a 360 degree grip or force on the stud. You should be able to...