Recent content by Kenwood

I have 2 A's, one is a 6 volt and one a 12 volt. I want to install tachometers in both cars. What type of and where do you suggest .to buy them. Nothing fancy, make, model and approx price Thanks for your input

Some of us in the US run alternators instead of generators. They seem to have less problems. A lot of people have installed another taillight on the rear fender, turn signals, seatbelts, spare tire or innertube. Before you reach our shores with your A I would be sure that all lights, horn...

Thanks everyone for the input about the dropped axle. Maybe when it was installed they had hydrolic brakes. My $100 purchase will continue to lean against the wall. New shirt comment: The dropped axle is not in the car as stated so you must be referring to the 16" rims. I changed the rims after...

A couple of years back I purchased a 3-4 inch dropped axle I believe it to be made from an original ford axle because it has the Ford insignia I also received 2 bars that went from the axle back to the frame The setup probably came from the 50's It's definitely a Model A front axle except...

I have a 1931 SW 4 DR that needs to have the interior metal trim,/dash done in wood grain or whatever it is supposed to be. I'm not afraid of doing it myself. One reason is the car is just a driver so it it turns out to be a 7 out of 10 job it's better than contact paper that is on there now...

Hi Leonard I have some Vicki front seats that need to be reworked. I will sell them. Not sure what year, early or late. Someone told me that they were Vicki seats and possibly late Get ahold of me and maybe we can figure it out. Ken

There is a a number stamped on the head A6050 Can anyone tell me what this means? High compression? After market?

I have a late model 1930 coupe I want to replace the wood header only above the windshield The previous owner installed an exterior metal roof which the sun visor is attached to Is it possible to replace the wood header without removing the metal visor? This car is just a driver the...

I need measurments to extend rear bumper braces and location and attachment of body stands for rear braces Thanks Ken

Pat: I am in Placerville. I removed my 29 7 tooth p/u steering column and I need to replace the wire. The kit that I bought, the lower plastic that I think slides into the tube does not fit. The inside of my tube is about 190 thousands. I measured another 2 tooth steering column and that rod...

I have a 29 p/u 7 tooth. I am trying to replace the horn rode wire. In the kit I bought the bottom plastic does not fit inside the tube. Any solutions