Recent content by jj1928

Original Points ... CS30 Echlin $19.99 Original Cond. ... FA5 Echlin $13.49 They might have to order them

thank you!! I have looked in Les Andrews book and on the barn with no luck.

I am installing new front spring perches. Is there a specific amount of torque for them or do you just get them as tight as you can ? Thanks

Thanks for all the help. This seems to be mystery compound with no definitive ingredients so I guess I will try the WardAz solution and see how it looks. Joe

I am building a show distributor and I need to know if there is a vendor that sells the Wax plug for the condenser. I have never seen one so I don't even know what it is made of. :confused: Any help would be Appreciated Joe

Check for a cracked rotor. If everything else is showing proper voltage this may be your problem. I have had this happen to me.

The Fuel Valve page should be page 2 Think all the rest are in order

I think it has a multidisc cluch but am unsure. It belongs to a friend and is unfamiliar with the car. it does have the 1/2" drive and i think it is the Able:confused:

I have an early model A with a bad starter drive and am unable to find a replacement. My question is will a later starter work as a replacement?

Thanks Steve. And yes i am a member of the Capitol A's (also President 2008 and 2009) hope to see ya in July for the National.

I need a little help finding the dimensions of the rear side window glass on a 1928 tudor. This is the one that rolls up and down. I have searched the site but have had no luck. :( Any help would be appreciated! Thanks in advance

they seem to come on the 1/2 inch fitting. if your are not showing it I have been able to get the two piece fitting by getting the 9/16 fitting (nut size)

Did you disconnect the brake light wire from the switch to the brake lights snd connect the wire from the signalstst to the switch? I had the same problem and that's what it was.

That's works it shows the differences Joe

I have seen this before but can't remember where. (senior moment) There was a picture with the differences between an "A" & B Cam. Does anyone remember it or knows how to tell the differences. I tried searching here but got nowhere. Thanks In Advance