Recent content by jiw1

i am having this problem on my 46 merc new off shore right side rear wheel cyl. is leaking.it is leaking on the 11/8" side of the cyl.what do i look for and what can i do to fix it ? thank you,ij

can someone tell me what size tubing to use on a stock 46 mercury and where does the fuel come out of a new tank. the new tank does not have a opening at the bottom. thank you

ok will try thank you both

42.thank you for the pictures.my switch looks the same but i can not move shaft i think from sitting maybe 30 years it is stuck.can these be taken apart to be repaired.

my switch barley moves because of a cotter pin going throughthe stem on the switch,would you have a picture of the bottom of the switch so to compare ? also whitch hole in the firewall does the hose go through to the carburator ?

forgot to ask how much movement right to left does the switch move ? thanks again

ok 42 thank you so much i will follow these instructions

does anybody know where the vacumm hoses go to on the switch? there is three ports on the switch and two on the motor,where do all three hoses connect to.i tryed to load pictures with no success.please help,thank you

good luck charlie i pray all goes well,john

thank you 48 will do

a couple of years i removed the dashboard from my 46 mercury coupe and now ready to install it, if i remember right there was some type of gasket between the cowl and the dash. my question is,is there a gasket and what is it made of and where can i purchase one ? also do i need to remove the...

trying to get another picture posted

another pix

tj, thank you for that info. auto stud,your info is very reasonable but in my sight doing it that way does'ent seam to line up with the top mount (in my line of sight}unless the top mount is relocated,is that what needs to be done?

i looked up 1970's front shocks made by monroe and they are to short,there extended length is 14.63". my top to bottom or center to center is 17'.