Recent content by Jim Haskins

I have a 39 transmission for rebuild. will need input shaft. I comes with shipping box made by Vanpelt. I also have a 37 trans. rear x mount $75

I have a pair of 1936 headlight rims. They are stainless and in very nice condition. No dents or rust Satisfaction guaranteed $50 shipped lower 48 SOLD

Thanks much to you all. I guess this fender has seen some body work!

Sorry Guys, I don't know where my head was at when I wrote this thread. What I intended to ask is there a difference between the 36 5 window and a sedan front fender. One of mine is more bulbas and round on lower front and extends past the end of the bumper several inches further than the other...

Is there a difference between 1935 and 1936 front fenders? I am aware of the rear fenders! I seem to have two different fenders, one has much less of a ridge down the center and it does not seem to have been worked on too much. thanks

I do not quite understand. this box does not have the two finger sector or the top cover of the 36 style,but has a roller sector and worm gear. and it will bolt right in my 36 coupe. when viewed along side of the 39 box they look the same but with the smaller bolt pattern. It does have the...

The number is on the bottom side of the box. the same location of the 39 box I have that is stamped/cast 78-3550 B

My green bible only shows a 3548 part number for all steering box assemblies. This box has the appearance of the 39 box but is somewhat smaller, mostly on the mounting side?

All discussions that I have read promote installing a 37-39 steering to improve the ease of steering in a 36 car. To do that the frame mounting bracket either has to be replaced with the later bracket which is no easy feat or modify the gear box holes to make it fit. Now I find a gear box with...

I have a steering box marked 01-a 3550. It has a roller sector gear and will fit the 36 mounting bracket. I have never seen this number nor heard of a roller sector in 1936. 1 purchased this gear box from a vender I North Carolina.

This was one of the hardest jobs on my restore. you will be lucky to save the joining bar that the screws thread into without ruining the threads. I made new bars and used 10/32x3/8 oval head screws

Listen to Mac vp he knows what he is talking about. There can be problems with throw out bearing and carrier using 0.5 pressure plate.

I have a intake 2x2 intake manifold that was on an engine that came out of a car in the late fifties. It is definitely of the Hexagon 2x2 design But is marked with Evans in the normally Hexagon Places. It is in good condition with no cracks or stripped threads. If interested make me an offer. I...

Can a 1936 steering box be modified to accept the 37 roller to replave the original sector. thanks. Jim

Thanks Charley, looking forward for one of your excellent carbs. Jim