Recent content by jerrytocci

Can I jack up the front of the engine to clear frame and pulley? Thanks. I have float-a-motor rear.

Parts are worn and pin is a bit short. Is there a trick to get better performance?

I have the condenser on my plate. His is in the dis. body. Both advanced. I am going there with parts and more time, soon.

My friend got an A and the points are at 12:00 . My car's points are at 1-2:00. What it right??

Should I be happy that my car uses no oil after four years? I drive it hard and change oil every 500 mi.

How do I tell if my gas cap is vented.

The GAV knob was loose on the rod and the needle valve leaked

My Zenith still leaks after testing fuel level (I bought a level tester) re-gasketed most of carb changed shut-off valve and looked for cracks many times. This a pro rebuilt. Is it possible a gasket is missing or maybe a bad jet? Also. I cannot get good results from curb adjustment or GAV.

The gas station was to blame. Several complaints were filed against it

It happened again , a few days ago. And the problem is/was the gas station. Several complaints were against the station.

Runs good even in the Florida heat. Glass fronts and steel rears

Blast it, glass it and use a pickup bed undercoat

Hi folks, I am getting a noise from the engine or somewhere else, this only happens when I accelerate and when the car is moving. Any ideas?

Low on cash

One of a kind woody.runs good.