Recent content by hpk 53

thank you for informing me

heads cast org head. not aluminum, 8ba heads you cannot get bolts , this has studs

8 ba

what sizes are long studs , medium studs ,short , where do they go , building rebuilt engine

hello I can tray anything , ill give it a tray thanks

building a 221 flathead , i can tune 1 valve on each cylinder going up , can not going down , tool slips out of tappet will not hold from turning, , have not tried different ways ,need help

40 ford , flathead U joint what grease to use .

i have a 1940 car wear can i find engine to transmission mount, it is 2 pieces 1 has a grease fitting , mounts around drive line end, picture shows the part

thank you all , i willtry out

I have a 1940 221 flathead , how do i install thermostats , i know they go in upper hoses

I did he is rebulding one know thank you

thank you

i have a 40 221 engine how do i set fuel mixture , its over fueling black shoot on plugs runs rouph

Ing resiator # 2 instaled new resiator what is the coil volts is it 6v or lower .

thank all ,i found the problem