Recent content by Heard

Kube, I will post some pics soon. I spent about 3 hours the other day and ALMOST got one of the fenders on. Unfortunately, I'm now back in NC for a few weeks so I can't get it done for a bit. Now that I've gone through it on one fender, I think I can get both on relatively quickly once I get...

Hey fellas, I thought I had all of this worked out but now...not so sure. Which one of these pics is correct? Or are both of them wrong? Thanks!! Heard

Thanks guys. I think I have a plan now. Heard

Thanks a bunch Mike. Exactly what I needed.

I'm finally ready to mount the front fenders on my '35 pickup and I need some help from you guys that have done this. Does the welt go from end to end of the fender? If not, can someone post a pic please. Any tips on installing the welt? I would think it should be glued in some fashion to the...

Thanks Mike.

Is this true for 35 pickup? Pretty much all of this welt, if it was there to start with, was completely gone on my pickup. Thanks, Heard

I'm trying to get my fenders and grille shell installed for the last time (I hope). Do splash pans go under the grille shell or over the grille shell? Thanks! Heard

Thanks, Bob.

It looks like the pic. I was thinking of putting it on the glass and using the trim to hold in place but that just didn't seem quite right. It doesn't really make sense to me that once I send this truck over to the upholstery guys the glass is going to fall out when they take the trim off...

What is the proper way to install the rear window? It appears from the rubber seal I got that it should be glued to the cab opening somehow, then install the glass using the pull string trick. Then the trim can go on. Am I on the right track with this? Thanks, Heard

Well, not sure which radiator I have since it is from Brass Works, but the original rods fit correctly and are right at 29 1/4" long. I got the new ones to work after cutting them off and adding to the threads.

I was hoping you wouldn't say that.

I have one of these regulators in my '35 pickup that is set up for 12v. The 6V gauge reads about 1/2 full when the tank is empty. The sending unit is from Drake that I bought along with a new fuel tank. Can I just add some resistance to this circuit to make the gauge more accurate? Thanks, Heard