Recent content by grinch

Anyone know the thread size on early ford tie rods? I thought they were 11/16 X 18. Some are saying 11/16 X 24? Never run into a 24?? Thanks

thank you Stewart i am all set now....thank you for the reply........Jim

looking for a place to buy 3/4 ton ford taper locks that go in the axle shaft of a full floating rear.......the are the split pyramid looking piece that helps center the axle......i need 16........thanks for checkin....j/m

Looking for a mercury pressure plate #10A7 for a core or a decent usable one. Lv message or call 978-356-4951. T/y. Jim

well that was fast.......it didn`t occur to me to try e-bay but that piece is exactly what i think i need.......thanks for pointing that out to me.....i will buy this and use it to do some experimenting........thanks to everyone that replied....... j/m

i wonder if anyone could post pictures of a 1946-48 ford clutch equalizer shaft i believe it has one end slotted at the bellhousing end and on the other end it is supported by a round ball and 2 half round bushings .....it also should have a small lever/arm off of the shaft too.....perhaps with...

Re: 1950 Mercury 8CM Flathead engine block, 4” crank and other parts. hey folks.....got the parts i needed......am all set for now......thanks for replying...j/m

need pressure plate from 1950 mercury......lv message etc....thanks

Re: 1950 Mercury 8CM Flathead engine block, 4” crank and other parts. am interested in flywheel clutch disc and pressure plate jlmartel14@aol.com or call 978-356-2226....thanks