Recent content by goleafsgo_12

Another photo

Original 1934 Ford Grill. All bars are laser straight, no rust holes, unmodified. Also comes with original, riveted hood lacing, crank hole and factory emblems. This piece hasn't seen the light of day in 25 years, with the dust and cobwebs to prove. Beautiful patina or restoration ready. Serious...

For sale are 3 original Ford Roadster (1930/1931) panels which are in workable shape, have been media blasted and primed with Dupont epoxy primer. They also come with 2 brand brand new lower patch panels, stamped from Brookville Roadster. They were removed with as much care as possible, without...

Thanks Marco, thats exactly what I needed to know. I do still have the quarter panels, but the bottoms were rusted out so no tab was evident. Thanks for the help!

JW, thanks for the reply. The part that I was initially reffering too was the hole located in that tab, hanging down from the door hinge post. As seen in the 1st picture, there is a hole in a tab that almost connects with the flange on the apron, but not quite. Do those holes need to connect...

Does anybody know if the bracket that hangs down from the lower cowl is supposed to connect with the hole in the running board flange? I am trying to setup the running boards on a new chassis and want to make sure my alignment is correct. Thanks

Ah really? They are a poor fit? Basically, the guy before me felt compelled to replace the section with a proper panel, however the proper panel was 2" too short, so he added some galvanized sheet metal between the 2 parts, hammered it into a relative shape and then tacked it everywhere. The...

Hey guys, I'm looking for the tall corner replacement panels for a 30/31 roadster. I have found one site that sells a 9" tall replacement, http://www.fordor.com/category.cfm?startrow=21&action=prev&dept=2831modela&cat=1930%201931%20Roadster%20Model%20A%20Ford&sort=title They are $130, 2nd...

Cool thanks for your help everyone.

Hmm.. Any closer shots? I can't tell if there is a hump just after the rear cross channel or not that I need to incorporate. I lightened and blew up craig's photo but the resolution is too small to see any details.

One more part.

Does anybody have pictures of their sub rails in this location? (see picture) I want to know if the patch panel I need to make is just a straight piece that matches with both sides, or if there are any other bend lines/ holes/ etc that I should be aware of. Somebody has cut this rail and put...

Here is a better picture of #5. Roughly 1 foot long (from memory). Its a formed channel with curved ends, about 5/8" thick. For the seal covers around the steering column (10), where do they mount on to? Is there a left and a right?

Awesome, thanks Luke!

Its time to play name that part. Who knows what bracket is what/ and goes where? 1 through 12, have a look. I have.. well.. no prizes.. but you get forum bragging rights!