Recent content by Gerryde

Yes spending lots of time in the garage working on my 28 model A roadster pick up,eg rear mudgaurds

Hi folks my model A r/p i got a wheel well and cut the mudguard and fitted the wheel well in the mudguard worked out very good. Cheers Gerry.(NZ)

Hi thats a bit rough on us kiwis

Hi Russ at the moment i have done all the side panels and the panel at the back. its the wood work that goes in on the side panels and the wood work that goes in on the back panel.The seat fram is sitting in there as well . Cheers Gerry(NZ)

Hi folks,Iam in the process of doing the wood work on my 28/9 roadster pickup.its the woodwork for the scuttle around the side panels and the back panel .If anyone can help it would be very much appreciated.thankyou. Cheers Gerry.(NZ)

Hi Thankyou Dave for that ,i will do that,Cheers Gerry (NZ)

Hi many thanks for your reply,i was scratching my head there as to where it would go.once again thankyou. Cheers Gerry(NZ)

Hi folks, at this stage i am setting up the body blocks on my 28 roadster p/u. It says that on the chassie side of the wooden body block there is a rubber pad,now i have done that on body block 3 and 4.The question is dose a rubber pad go on the front body block 1 .2.3.This is for a steel sub...

Hi yes the roadster pickup is a canadian built truck. The sub fram is all steel. cheers Gerry (NZ)

Hi thankyou for your help so far,iam going out there now and will mount the petrol tank,so i can put the hood on for a better alignment. Thank you all for your help so far,will get back to you soon. Gerry(NZ)

Hi folks fitting the body of my 28-9 r /pickup.the door on the left side is up about 3/4 off an inch ,do i put a pad under which body block or is there some other way. Could someone please put some info for me..many thanks. Gerry (NZ)

Hi what is a skuttle ! A skuttle is what is called a front cowl .cheers Gerry (NZ)

Hi folks,at the moment iam putting the two parts of the skuttle together,the front part too the door pillers. when this is bolted together is it recommended to put a sealer inbetween the two parts before bolting it up. My thoughts are that its a great place to get moisture in between the two...

Hi folks i have had model A orders sent out here to New Zealand seven days turn around from time sent of order, very very good and great service. Cheers Gerry (NZ)

Hi manny thanks for your replys, i have been out and yes its all done.and fits really good thankyou. I dont know what i would do without the knolage of this fourm.Cheers Gerry (NZ)