Recent content by Gary57210

Where did you get that one?

What does everyone use as a cup holder? I was wondering if there any 3-D printed ones out there

I have found one.

I'm looking for a gas gauge that I can refinish. All I need is the part with the markings on it. If you have this or this with the arm, I could use it. I really don't want the whole unit with the bezel, glass etc. thanks for any help.

Is this a bolt in swap?

We put a set of WW European Classic from Bert's on our 31 SW sedan. They seem fine, but don't have too many miles on them yet.

Thanks for the suggestions, I'll give it a try

New rebuilt Zenith-2 and the GAV is very tight and hard to turn. It acts like it's dry and chatters when you try to open or close it. Any ideas or can this be adjusted?

Wow, they look great! I have started to whittle down the mounting portion of my passenger arm. I've got it almost where I can use it. I may leave it where it is now and add a convex mirror on that side.

Mine look similar to the ones Bob has on his Vicky

Bob Do you have a picture of the mirror looking down from the top? Yours looks like it is narrower than mine. thanks

That would be a great help. That way I would know which side they should be on.

I don't think so. I've looked at some pictures of other cars and the arm on them is on the top.

These mirrors were on the car when we got it. The arms angle to the front instead of to the rear, making them impossible to see out of. The car is a 31 S/W for reference. If someone can see a problem, I sure would appreciate some ideas.

Hopefully I found the problem. I was going through and changing the jets with new ones. When I measured the old main jet it was between a #76-78. My search showed that it should be from #63-64. After changing it the problem seems to have gone away. time will tell. I have attached pictures of the...