Recent content by flathead 1150

1955 F100 original drivers rear fender, with left and right steps. very good condition. Fender has well for spare tire.

I purchased a 30 CCP, when I was checking the steering box it had grease in the steering box instead of 600w oil. The truck has no steering issues at all, I read on this forum about John Deere Corn Head grease being used in 2 tooth boxes, so I purchased some, which I plan on putting into the...

Checked the problem today, disconnected the horn and lights went off reconnected the horn and everything was normal. Going to check again tomorrow not convinced that problem is resolved.

Just checked the truck in the dark and what I thought was parking lights were dim headlights when I instalied the fuse no tail light. when I turn the headlights on with the switch the headlights come on bright along with the tail light. Will remove the switch and see if there is any issues.

Just did a complete wiring harness on my 30 CCPU, and now the parking lights stay on in the off position. There were no issues prior to the new harness, I did use the original switch. Any Thoughts, Thanks

1955 Pickup Drivers side rear fender with spare tire wheel well Call Rick 203-545-4905

I checked for spark by grounding out the coil wire and opening / closing the points and had a nice blue arc, however never checked the gap on high point on cam, after resetting the truck fired instantly!. 30 closed cab found after sitting in garage many years. Nice older restoration. Runs /...

Thanks for the information, got the truck running today, new intake & exhaust manifold not the problem

Thanks, got the Truck running today

Thanks, article in November / December Restorer magazine page 37 statesbe sure to have the new intake and exhaust be surfaced prior to installing,

Yes, plenty of fuel

Thanks some books are saying 60 lbs. The model a engine by William Mcree most likely a misprint

Will go through everything again tomorrow will post again Thanks

Plenty of fuel and nice spark from coil wire to ground

Should new intake and exhaust manifolds sent for surfacing prior to installtion?