Recent content by Doughie

That is exactly how my 41 looked before I added a reverse eye main spring and removed a few leafs to soften the ride. Also added tube shocks and had to remove the bar to make them fit. Car handles good and drives straight. A little squirrely if I hit a big bump or nasty manhole cover but corners...

Simple fix. Loosen the two bolts at hinge and one inside above the kick panel. Gently pry the hinge up using a 2x4 and pry bar. Mine only moved about 1/8" and hood sits down nice and flush to the cowel. Hope this helps.

Same problem on 41 hood was up on one side at cowel. Easy fix with the hood open. Loosen the two bolts holding the hinge to the fender. Loosen one bolt holding hinge to the fender above the kick panel inside the car. Now carefully pry the hinge up. Mine only moved less than 1/8" and problem...

For those that need to know. If your homeood sits high at cowel. Loosen two bolts under hood that hold the hinge in place and one inside above kick panel.Gently pry the hinge up. Mine only moved about 1/16 inch. Hood sucks right down tight to the cowel! So simple but frustrating if you don't...

For those that need to know. If your homeood sits high at cowel. Loosen two bolts under hood that hold the hinge in place and one inside above kick panel.Gently pry the hinge up. Mine only moved about 1/8 inch. Hood sucks right down tight to the cowel! So simple but frustrating if you don't...

Just finished installing tube shocks on front of 41 sedan. Ordered "Vintage" bolt on kit. It does not fit as advertised. Neither does anything from Speedway. Ended up bolting 2x3 tubing to frame then attached speedway upper mount to it just to clear the sway bar. Not pretty but it works. None of...