Recent content by diggidy

Original top receiver plates for the 1959 ford retractable. These have some pitting, but could be refurbished. $30/pr plus shipping. I accept Paypal

I just came in from the shop. I am able to get the flywheel to move a complete revolution by prying on it, and the front piston that seemed to be stuck is now moving. I'm going to get the owner here tomorrow and we will pull it slowly in 3rd gear to get things moving easier. Thanks for all of...

I took the starter off and can turn the flywheel both directions about an inch with a prybar, then it stops, so it must not be the pistons. Must be a stuck valve. Would slowly pulling the car break it loose, or break something else?

A friend has a '29 roadster pickup that he had the motor rebuilt in 2006, and it had been sitting out of the car wrapped in plastic since. He asked me to install it and get it running. I was worried about it being wrapped in plastic all of these years, but it appeared to be clean and rust free...

Trunk lid support for the '37 ford sedan. It has been sandblasted and painted black. $75 plus shipping. I accept Paypal

I took these side trim pieces off of a '59 Ford retractable parts car years ago. I think that there might be a piece or two missing to be a complete set, I've had them stored for quite a while. Some have some dings and dents in them. $100 for all pieces plus shipping. PM me or email...

It's been a few years since I took the windshield out of my '34 pickup and am in the process of installing it. I was wondering if the hinge is installed with flat headed or round headed screws, or if it makes a difference. I can't remember what I took out when I removed it.

Btt

This '41 came into the salvage yard that I sell for. Very solid body. Complete with flathead engine. Boom is homemade like they did back in the day. $3000, no title, sold with a bill of sale. Located in central Wisconsin. Call Bob at 608-547-7794 if interested.

Bump

'53 Ford COE is mostly complete. Has rust issues, bottom of doors and cab corners. Flathead was running 2 years ago, but needs tuneup. No title, sold with bill of sale. $2800. Located in central Wisconsin. Call Bob 608-547-7794

I just purchased this '28 roadster and it seems to run good, but the steering is tight. It seems to be at the column. I've greased the box and front end, and all of that seems to be fine, so I'm thinking it is in the column. Is there a way to lube the top bushing in the column? Or does anyone...

I use Simple Green and a plastic scrub pad on my whitewalls. Works very well. Coker does not recommend using products like Bleach White. I used to use it on white lettered tires, but didn't want to take a chance on my new whitewalls.

'35 Ford inner fenders, good condition, but one will need some repair around the lower holes $75/pair '35 Ford headlight buckets, the ring on the one is poor, missing on the other, one is dented around rivets (see pic) $30/pair '35 Ford headlight stands $20/pair Plus shipping

These were taken from a baby Lincoln, same as Mercury. Complete set including dome light. $75 plus shipping