Recent content by Derby

Many thanks. Just what I needed!

I was unaware that the fuel gage and sending unit are bi-metal units. I would appreciate a more complete explanation of how they operate. Does the Drake sending unit use a bi--melal strip also?

Received the Drake tank for 37 slat back. Installation was straight forward with just enough clearance all around. Almost zero clearance between top of tank and bottom of trunk floor. Just enough to allow tank flange to clear frame rail. Satisfied with the product.

Just removed old tank from 37. Drake replacement on the way. When lifting the body, how much is "a bit?"

TerryOH, I may have the original tank rebuilt. My objective is to be as well informed as possible. I need to be sure any tank used its super clean.The modified engine in the car uses an 8BA block with fuel injection.

G.M. & TJ Thank you both. I feel much better prepared.

After reading the excellent discussions about removing the original fuel tank, I have a question about a replacement. In a post dated 4-2-2016 Dennis(EV8G) included this statement: "Just to make you aware should you decide (for some reason) to replace this tank, Bob Drake reproduction tanks for...

Kilroy was here!

Great! Thanks for the quick answer.

There is an excellent post by JSeery dated 4/6/2015 concerning gauge operation. After reading this information it appears to me the the gauge operation is unaffected by a change from positive to negative ground. Is this conclusion correct?

OK, great responses. I will proceed cautiously. While doing some previous tank work on a different car someone suggested putting some dry ice in the tank. The dry ice sublimates and releases CO2 that displaces all gas vapors with a little patience.

The fuel tank outlet tube on my '37 is damaged and needs to be replaced. The retaining nut fitting has been rounded off and will not accept a wrench. Prior to my attempts to loosen the fitting, I am asking for help in understanding the connection. The tube must extend about three inches through...

OK, thanks. I will use front holes with radiator on top of the rubber pad on the frame mount secured by the springs and bolt.

Is this the correct mounting assembly? The picture shown is how I found it. The radiator tab is on top of the rubber pad. The bolt is through the rear hole on one side and the front hole on the other. The car is a '37. I am in the process of installing an 8BA and the radiator position is...

What is the correct length for a '37 radiator? I am not sure the ones I have give the correct tilt.