Recent content by dantucker

Yes, I have searched E-bay, MAC's, Classic Auto, Dearborn and many others with no luck.

I am in need of 2each sun visor arm and brackets for a 56 Fairlane Town Sedan, the part # I have is B6A-7004144-AP. The only thing I can find is the one for the convertibles. Does anyone know if the one for the 56 pickup will fit? any help would be appreciated.

here yo go. http://paintref.com/cgi-bin/colorcodedisplay.cgi?dupont=2221H&rows=50&syear=1956&smanuf=Ford&smodel=&sname=Mandarin Orange

WD40will usually break down most adhesives, spray it on and let it sit for about 10 minutes then rub it off.

See if this is what you are looking for. http://www.tcpglobal.com/aclchip.aspx?image=1955-ford-pg02.jpg

They took the vacuum for the wipers from the teapot carb. The distributor came off a "T" just below the fuel intake and the wiper vacuum was taking off the front of the carb.

Had a delivery problem on my 56 Fairlane and like Motorhead6 I found the fuel line between the tank and the fuel pump plugged. Using a fuel bulb from an outboard I forced SeaFoam through the line at the fuel pump end and let it set for about 30 minutes. Good fuel flow now!

Thanks for all the feedback!

The wipers work, just do not want to lean out the back two cylinders.

New here, great site with lots of information, my first question. I have a ECZ 9425 B intake with Autolite 4100, the valley pan had the rear draft setup on it and I put a PCV valve in it and ran it to a spacer under the Carb. I am currently using the port at the rear of the intake as my source...

The instructions I used indicated you could eliminate the resistor when using the petronix coil, everything is working fine on my setup!