Recent content by CLD1950

BRENT in 10-uh-C, I thought about part of that, notching the ferrule with a saw and then using a flat-head screwdriver in the notch to crack the ferrule off. The annealing is the crucial step I suspect. Thanks Clint

Thanks to all for the advice. I think I will purchase a new line with the ferrules but try Marshall's suggestion on the old one. Regards, Clint

I would like to replace the compression ferrule on the stainless steel gas line at the carb end. The nut slides freely on the gas line but the ferrule is tight. I would like to remove it and replace it with a new ferrule. How is this done without possibly damaging the gas line. I am working...