Recent content by Bubba

First I won't THINK all for your feed back It was fresh water The pan had 1 1/2 gal water transmission 1 Qt. rear end 0 for some reason Master cyl. 0, and it was 6" under I had jacked the front up had no water in distributor so it fired up an I backed off the brakes moved it back and forth to...

Need help on what I need to do first It got about 24 inches, drained engine, drive train etc may Need tips on pulling wheels maybe should have ben first see what I can do today I'm 85 and I know they can be tough and so many other things to try to save. Have or had a top notch 8BA out back...

I know this is a dead horse but I do not see anything I like Too much CHINA by the way I live about 15 miles from China Texas and they don't make anything there just GROW RICE If any one can help on who has the better parts, cylinders, lining ++ are we better off rebuilding cylinders...

Will got what I could done the IC7 coil and I had an FA54 runs better than it has in a good while cap and rotor won't be in for 2 3 days. Thanks

I had seen that for a crab get 52-1902 coil and FA49 cond. got them a NAPA got home had the FA49 and IC7 coil coil say no External Resistor required Is that what I need to run and by pass the resistor under the dash or go back change for another one. Thanks

Back in the 40s my uncle had a almost new 41 Ford PU. Going down the street at 4 MPH as he turn on the side street give it full throttle when we crossed the next street we were at 44 MPH smooth all the way. On that same street my 39 pulls Smooth all way but I have not got it down to 4 mph...

On my 39 did not have a hand crank handle So I jack up the right rear put it in 3rd gear SWITCH ON turn wheel to right (clockwise) Back in the 50s that was every day not enough money to get good battery. Bubba

Easy off will eat aluminum if left on very long. Berryman B--12 Chemtool works good also. Spray or pour on.

Not sure about ALL but the ones I have slide push---pull not screw. Two 39s two A models. Maybe some screw some one will let us knowI'm sure Good Luck Bubba in Texas

5/16 nf

Go down to the store and get a little jar or can of Molasses mix it with water 3 water to 1 molasses in a tray enough to cover the plate leave it a few days check it, light rust a few days more for heavy rust. It will not hurt the paint most times it will brighten it up. Check it out on another...

Warren Oil Co. inc. Makes Type A They are in NC, AL, TX, IL, PA, AR Hardware store hear in town has it. Made in USA

In southeast Texas it Rained almost every day this month mist two or three but some days it rained twice to make up for the ones it didn't.

Some one may have already put this on if so I didn't see it I need a exhaust manifold they said sorry were out of business SAD Sad this is Stacy Brown in Arlington Texas Bubba in Texas

Exhaust Manifold need Right side with the port for cross over 5 "five" inches back from the top front bolt 1939 with 59 type motor Thanks