Recent content by bmwillia

Thanks! Just ordered one from you.

Is there a single groove/single belt option for a 59ab Crankshaft pulley, or is the only option to cut off the front of a double pulley?

Steve, Not 100% sure but I don’t see any other issue and that knock noise does happen turning the input shaft by hand every time the broken tooth comes around. I don’t see any evidence of the pressure plate hitting anywhere and it’s been running quietly for around 1000 miles.. These...

Went back out and turned the ****** by hand and sure enough there is a "knock" sound every time that broken tooth on the cluster comes around. I missed it last night, but it's there. Here is a video: https://youtube.com/shorts/AeLKNMEjyc8?feature=share

I'll look into this.

When I first started troubleshooting I did this. The was a broken tooth off of the cluster gear sitting in the bottom of the ******. I removed it. When spinning the ****** by hand now I don't hear or feel anything different when that broken tooth comes around on the gear. Have had other...

Checked the springs on the plate and the disc. everything looks fine.

Clutch pedal out across the in neutral = noise Clutch pedal in and clutch not spinning, no noise.

I do have the proper play in the clutch pedal and I forgot to mention that I started with the throw out, put it all back together and the noise was still there. Terry, I thought about that. I'll see if I can see any signs of something hitting in the bell housing area. Nothing jumped out at...

I have a knocking noise that started while driving the car it is coming from the bell housing area. The noise started after I ran out of gas, put gas in the car and was heading home. the noise goes away when the clutch pedal is in and the clutch stops spinning. I have viewed this through the...

Thanks for all of the input and suggestions. I’ll update when I have a solution. Sent from my iPhone using Tapatalk

I’m not sure what it’s made out of, but I’m pretty sure it’s modern. The motor was built by H&H. Sent from my iPhone using Tapatalk

There is a small oil leak from that area when the engine is running. Sent from my iPhone using Tapatalk

Here is the only picture I have of the pulley. It’s not a great one to see the part the goes toward the engine. This is before the front pulley was machined off. Sent from my iPhone using Tapatalk

Hey guys, I have a fresh installed 59ab in my 33. I noticed a squeak/chirp coming from the front of the motor and after investigation I have found that the crank pulley is rubbing the oil pan lip. The motor came with a double pulley on the front and I only needed a single so I took the crank...