Recent content by Blase

How do I install a pin into the door handle.

how to add oil to the rear end of a 1948 ford Columbia Rear End, also there is one nut located at the very bottom of the Columbia which is attached to the main gear box leaking very little. Can I remove that nut and add gasket sealer to it or can I add a "o" ring to the nut. which is better ?

I when to change my ignition switch and noticed on the back of the original one I removed had 3 pins. 1) Marked Coil, 1) Marked GA, 1) Marked AM The new switch has Bat. Coil, and GA marked in the back. So, what does AM Stand for?

I have a 1948 Ford, new battery, new starter, new solenoid, new ignition switch, new starter button, full tank of gas. Car starter easy was running for about 10 minutes and just stopped running. My guess is I lost juice from some were, but don't know how to begin checking where I lose it.

The battery cables were on backwards to the solenoid.

Your right, that was the problem

Terry,Please clear space so you can receive new messages. I'm try to sent one to you.

Have power from battery to solenoid, to coil, to reg., and relay horn switch, ignition switch. Have no contact from starter button, no lights nothing. checked ground from battery cable to block and from firewall to block. looking for some answers and help.

If I touch the neg. battery post on a 1948 ford with a wire clip at one end and a light at the order end to the solenoid and the light goes on, does this mean power is going to the solenoid. If so , can a touch the solenoid with the wire clip and the touch the coil will the light go on?

Have power from battery to solenoid, to coil, to reg., and relay horn switch, ignition switch. Have no contact from starter button, no lights nothing. checked ground from battery cable to block and from firewall to block. looking for some answers and help.

Looking for the easy way to change the circuit breaker on a 1948 ford. The circuit breaker is behind the dash just above the gauges for the fuel , oil, amps and coolant. Also I have the original 51A-12258 which shows four contacts A,B,B H I know B is for battery what is A and H for.

I found out that they are 23 inches long. thank you

thank you I found out that they are 23 inches long.

Does anyone know the best way to put the Columbia Canister on so that the arm from the Columbiarear end is attached to the canister rod because its hard to view it and know that its in the slot.

Does anyone know the length of the speedometer cable going from the Columbia speedometer adapter under the hood to the speedometer under the dash