Recent content by BB Bfowler

Thats great info I will be ordering a seal from napa tomorrow and see if it works. Now I have to work through some electrical gremlins with the old wiring, ugh...

It is the ford design in the green book. I am going to scape it clean today and see if I can pull the PTO assembly off and inspect more closely. I am assuming that there were transmissions that did not come with the PTO option. Is there a blank cover that could go there instead? I have a...

I have my old BB up and running but the PTO drive shaft seal is leaking very badly. Has anyone replaced this seal? I found the part number in the green book but can't find anyone selling this particular seal. Do these seals still exist? I would greatly appreciate any advice on this thing...

sorry A-5630 is that the one?

Thanks Bob for the tips! is the model A rear shackle A-5630, the one that is the same as the BB-5715?

I worked all weekend on the BB, re-furbished everything in the whole front end except the shackles, I have a question about that in a second, tore down, cleaned and refurbished all the brakes front and rear, new linings all around replaced all the seals, new water pumps, new clutch and pressure...

Just ordered the spacers. Saves a little time in fabrication. should have the truck up and running in a few weeks...

Thanks for all the feed back! Are those engine spacers still for sale anywhere? Brendan

Where might someone find a owners manual? It appears that this truck, although it is a BB, is mostly AA with a V8. Before I pulled the engine, the crank hole was lower than the ratchet on the engine.

I am neck deep into my truck project and I am finally at a point where I would like to start putting things back together, but, I have lots of questions There are are different styles of grease fittings in various places on the truck. Is it because they were intended to receive different kinds...

Here is a pic of my new project

I am brand new to this site and I am also brand new to working on 30's ford trucks. I am about elbow deep in a little project on a 1933 BB 1-1/2 ton. It has a 1937 V8 other than that it is all original. I am going through the rear end and need to replace some seals, wheel bearing and axle. BB...

I am brand new to this site and I am also brand new to working on 30's ford trucks. I am about elbow deep in a little project on a 1933 BB 1-1/2 ton. It has a 1937 V8 other than that it is all original. I am going through the rear end and need to replace some seals, wheel bearing and axle...