Recent content by azandy

Is there a material I could use similar to plasti-gauge to do a static check on brake shoe to drum gap? I think it would give me a rough idea on where to remove material to arc the shoe to the drum.

Overdrive Solenoid 6Volt 4AR10B-62 1" shaft length $160. Includes Shipping After researching solenoid prices on e-bay I need to back off on the price.

Overdrive Solenoid 6 Volt 4AR10B-62 1" shaft length $160. Includes Shipping Check the picture--The original factory stamping was 6AR10B-62 then corrected to 4AR10B-62 After researching solenoid prices on e-bay I need to back off on the price.

Overdrive Solenoid 6 (12?) Volt 1118168 1" shaft length $160 Includes Shipping One application for this solenoid was a Ford car 1954 thru 1960. 1954 and 1955 was 6 volts 1956 thru 1960 was 12 volts Apparently, it will work either way. I tested it with 6 and 12 and it worked fine. After...

Re-submitted

Re-submitted

RE-submitted

I'm putting a 1971 Ford Maverick rear end in my 1950 Ford car can anybody tell me a part number for the rear conversion universal joint to fit the 50 drive shaft? Thanks, Andy

Wow! A great response, I'm not about to break into the rear end so I'll just replace the seal per your suggestions. It was not making noise so I think I'll be okay. Thank you Andy

I'm replacing the pinion seal on my 1950 Ford car. The drive shaft is out, the pinion nut, shaft and u-joint flange are marked and wheels are off the ground. When I rotate the u-joint flange by hand it moves freely clockwise and cc about 6 degrees before I feel contact with the ring gear. Is...

Thanks for the responses. Andy

Can anyone tell me, what is the diameter of the pivot ball for the clutch linkage on a 1940 - 1948 Ford car? Thanks, Andy

It's getting hard to get my knees under the steering wheel and hit the pedals on my 30 Coupe. Does anybody have an idea on how to raise the steering wheel a couple inches, is there a kit available? Thanks for any replies, Andy

I'm putting the Speedway Motors Tremec T5 trans conversion kit in a 1950 Ford car. Has anyone done this? *What crossmember can be used? ( Jamco has one that works with a TH350 ) *How is the 1950 clutch linkage adapted to work with the 1948 design? *I've got the new drive shaft yoke, will the...

I need the trans adapter for a 49-51 Ford car that will allow for the installation of a Tremec 5 speed transmission. It is 3” wide and I believe the part number is 8BA-6392. The 3" adapter will bolt to the Speedway Motors GM T5 trans adapter #91628912.