Recent content by 34 3-window

I am looking for the tack strip that fits above the rear window and attaches to with brackets to the wood framed rear window on a 3- window coupe, 1934. Opposite ends attach to each door post.

Thank you all!

What constitutes a Deluxe Coupe vs a standard? Cowl lights vs not, twin tail lights vs one, side mount spare vs rear? I know the trim inside is different but what about the outside? Thanks,

Re: 3 Model T’s for sale Hello to those interested, These cars and parts have been stored inside and as you can see by the pictures are a little dusty. ALL of these cars and parts are original Henry Ford metal from that era. Everything can be purchased together or separately. I will be posting...

3 Model T’s for sale I have 3 cars for sale, 1915 roadster with both wood felo and wire wheels, 1925 touring car, 1927 touring car with ruckstell rear end. They need finish paint and upholstery. I have some of the kits plus many other parts too.

Hello, I’m selling my Dads Model T cars and parts. The cars are: 1915 roadster with both a set of wooden felo and Buffalo wire wheels on the car, 1925 Touring car ( tall radiator), !927 Touring Car with original Model T bumpers, not Model A. Both the 15 and the 27 have ruxtell rear ends. Cars...

What is the best way to remove and install the grease seals to the 34 rear end? One in each half of the differential and one in the drive line.What techniques or tricks are the best? Thanks, Harold

Wanted: Matched set of ring gear and pinion for a 34 rear end 3.54 to 1 ratio. Will also need the matching speedometer connection. Have a very good 4.11 to 1 and speedometer gear , can trade. Also need high compression aluminum heads for a 33-34 engine. Thanks,

When using hydraulic backing plates, is it best to use 34 drums and hubs or 39-41? What about front spindles, use 34 or later spindles? I know about the kits that are avaliable but I was looking for those of you that have done it and are using a car with hydraulic brakes on a 34 Ford. Your...

How many cage nuts on the frame for a 34 ford? Are they all the same size? Thanks

Thanks gentlemen for the great advice. Is there anyone remanufacturing the K.R. Wilson tool for shackles and springs? Thanks,

What's the best way to remove the old center bolt and bushing out of the springs and spring perchace on the axle? Is there a tool of the right od diameter to drive out the old bolt and bushing? Should you use heat to the outside edges? What are the best replacement parts and from whom?Working on...

34 parts wanted: 1. front gusset's for 34, fits to frame rails and front cross member. 2. inside windshield moldings for 34 3- window coupe. 3. bracket with pedal arms for clutch and brake, 34- 5 bolt hole, holes in arms for pedal pads.