Recent content by 2xspinner

Thanks for that. Thought they must have been deep recessed screws. As I didn't disassemble the car wasn't too sure on fitting. Manual of limited assistance. Now reassembling it with all the new wiring in place makes it tricky. I appreciate your response, thank you.

Hi, this may have been asked before but seeking advice re reinstalling heater control Unit to the square hole in the dash. The knobs fitted to the slide levers seem to need removing to install but how are the knobs fitted, recessed screw or push in bearing type?? I didn't remove the unit...

Seeking column gear linkage rods and trans mount brackets for 51 Victoria by member EFV8C Southern Regional Group #117, parts needed for current resto. Price and freight covered by genuine buyer. Alternative a source. Many thanks

Seeking for current resto, column change linkages rods plus the lower trans mounting brackets for an overdrive 51 Ford, Victoria being restored. Genuine buyer in New Zealand for price and freight. Can you assist please?

Thanks guys for your replies. Yes I have the correct Ford bell housing bolted to the gearbox with starter plate fork etc.

Hi, I am new to the site and after some advice. Restoring project 1951 Ford Vic O/D car which I have in NZ. Has rebuilt O/D g/box and wanting to mate it to a rebuilt 49 Mercury motor. Issue - the 49 motor had fitted to it an 11" dia fly wheel too big for Ford bellhousing and starter motor...